Isothermal Properties for Xenon

• Fluid Data
• Auxiliary Data
• References and Notes
• Notes
• Other Data Available:
  • Use the interactive display. (requires JavaScript / HTML 5 canvas capable browser).
  • Download data as a tab-delimited text file.
  • Main NIST Chemistry WebBook page for this species.
  • Recommended citation for data from this page.
  • Fluid data for other species

The following adjustments were made to the specified data range:

• The specified increment was adjusted to limit the number of points calculated.
• Default values were used in place of limits which were not entered.

Fluid Data

Isothermal Data for T = 273.16 K

Auxiliary Data

Reference States, Normal Boiling Point Convention

Additional fluid properties

References and Notes

Equation of state

The uncertainties in the equation of state are 0.2% in density up to 100 MPa, rising to 1% at higher pressures, 0.2% in vapor pressure, 1% in the speed of sound, and 2% in heat capacities.

Auxillary model, Cp0

Lemmon, E.W. and Span, R., 2006.

Auxillary model, PX0

Lemmon, E.W. and Span, R., 2006.

Auxillary model, PH0

Lemmon, E.W. and Span, R., 2006.

Transport model

Estimated uncertainty for gas-phase viscosity is 1%, for liquid to 60 MPa and temperatures above 170 K is 5%. Estimated uncertainty for gas-phase thermal conductivity is 5%, and 3% for the liquid at pressures to 50 MPa at temperatures 170 K to 235 K.

The Lennard-Jones parameters were obtained by fitting data in Vogel, E., Ber. Bunsen-Ges. Phys. Chem., 88:997-1002, 1984.

Auxillary model, the thermal conductivity critical enhancement

Surface tension

Dielectric constant

Metling line

Michels, A. and Prins, C., "The Melting Lines of Argon, Krypton and Xenon up to 1500 Atm; Representation of the Results by a Law of Corresponding States," Physica, 28:101-116, 1962.

Sublimation line

Lemmon, E.W., 2003.

Vapor pressure

Cullimore, I.D., 2010.

Functional Form: P=Pc*EXP[SUM(Ni*Theta^ti)*Tc/T] where Theta=1-T/Tc, Tc and Pc are the reducing parameters below, which are followed by rows containing Ni and ti.

Saturated liquid density

Cullimore, I.D., 2010.

Functional Form: D=Dc*[1+SUM(Ni*Theta^ti)] where Theta=1-T/Tc, Tc and Dc are the reducing parameters below, which are followed by rows containing Ni and ti.

Saturated liquid volume

Cullimore, I.D., 2010.

Functional Form: D=Dc*EXP[SUM(Ni*Theta^ti)] where Theta=1-T/Tc, Tc and Dc are the reducing parameters below, which are followed by rows containing Ni and ti.

Notes

• Data from NIST Standard Reference Database 69: NIST Chemistry WebBook
• The National Institute of Standards and Technology (NIST) uses its best efforts to deliver a high quality copy of the Database and to verify that the data contained therein have been selected on the basis of sound scientific judgment. However, NIST makes no warranties to that effect, and NIST shall not be liable for any damage that may result from errors or omissions in the Database.
• Customer support for NIST Standard Reference Data products.